Page 1 of 8 123 ... LastLast
Results 1 to 15 of 112
  1. #1
    pearltime
    Guest

    Default Stringing Pearls

    Has anyone taken the peral stringing course offered by GIA? Can anyone recommend a good teacher or course?

  2. #2
    Super Moderator Senior Pearl-Guide.com Pearl Expert jshepherd's Avatar
    Join Date
    Jun 2004
    Location
    Marina del Rey, CA
    Posts
    5,794

    Default

    I have not personally taken the course, but I did require it for new employees for a time. I no longer do, however, as I feel it is a bit outdated. The method taught is tedious and time consuming. If you are looking to bead and make pieces other than traditional strands it would be a good course for you. If you only intend to string classic pieces I recommend saving the money and finding a local teacher. The best method is the tweezer-free method. After enough practice you should be able to produce a perfectly knotted strand in approximately 10 minutes.
    Are you near a large city? A lot of cities have a jewelry district similar to the one here in Los Angeles. There are a lot of stringers here who would be willing to teach. I paid one $200 for a full day class last year for everyone in the office that had not yet learned how.

    Pearl Knotting Video
    http://www.youtube.com/watch?v=O12P1OaMCe8
    Last edited by jshepherd; 04-14-2007 at 03:49 PM.

  3. #3
    pearltime
    Guest

    Default

    Thank-you very much for your prompt reply. I live near Atlanta.

  4. #4
    purepearls
    Guest

    Default

    I agree with Jeremy. If you can find an experienced stringer in your area, ask them if they would be willing to teach you how to string. You will save money and the one-on-one guidance is also a huge plus.

  5. #5
    Satine De La Courcel
    Guest

    Default Bead stringing Book

    HI Pearltime..

    A friend lent me a book it appears to cater to beaders however it teached two methods of knotting between each bead.. AKA the writer used the knotting method typically used for pearls for their beading as well..

    Its called Step by Step Bead Stringing by Ruth F POris, Golden hands Press 1995 It is a small soft cover book.

    I hope this helps

    Ashby

  6. #6
    pearltime
    Guest

    Default

    Thanks everyone so much. Is this what is meant by no tweezers?

    First, a knotted necklace must be started just as any basic beaded necklace would be. Though there a few ways to start a beaded necklace , my usual choice is with bead tips (clamp shells). The only difference is that two strands of the cord are inserted through the bead tip instead of one.
    Once the necklace is started, string on a bead, and make an over hand knot. Make the knot tight so itís snug up against the bead.

    Continue to do this: string a bead, make an over hand knot, string a bead, make an over hand knot. Thatís it. Again, finish the necklace as you would any beaded necklace whether itís knotted or not.
    The reason I call this a way to cheat at knotting is because normally only one strand of cord is used. However, this technique is simply and the results provide the same results as a single strand knotted cord would provide.

    http://jewelrymaking.about.com/libra...y/aa062899.htm

  7. #7
    purepearls
    Guest

    Default

    Here is the tweezer method: http://beadwork.about.com/cs/beadsho...etweenbead.htm

    In this description, tweezers are being used to help make the knots which makes the task more tedious.

  8. #8
    Pearl Maven Senior Pearl-Guide.com Pearl Expert Caitlin's Avatar
    Join Date
    Dec 2004
    Location
    near Tucson AZ
    Posts
    8,827

    Default

    Here is a link to a clear, step by step method of stringing pearls


    Henrietta Virchick's small book is a classic:Pearl and Bead Stringing

    She teaches a great hand knot method. She also teaches a method with an awl.

    It is a good altrnative to the Ruth Poris book mentioned above. It is a little more detailed.

    WARNING:
    Just about all the methods with links in this thread and both the books- actually show pictures of one sliding the knot with the tweezers- don't do it-

    No matter what method of knotting you learn, I do not recommend you insert awl or tweezers into the knot and slide the knot with them- it is too awful to do that on 45 pearls then have the knot slide off and tighten too far from the bead!

    RECOMMENDATION:
    Whether you use your fingers, an awl or tweezers I recommend one puts the fingers or tweezer through the large loose knot and grab the string right next to the bead and fip it through the hole. Then, keeping your thumb on the bead,start tightening the knot down to the bead. It will go to the correct spot every time.
    Last edited by Caitlin; 02-24-2008 at 06:49 PM.

  9. #9
    dutchpearl
    Guest

    Default here is how I do it

    All the descibed ways to knot a pearl necklace seem awfully complicated to me. So here is how I do it.

    First the stringing: I get the pearls delivered to me on a temporary double line of threath with a knot on both ends. On one end I pull hard on one of them, so it breaks near the knot. The other one I split and cut all parts exept for one.

    Then I take a threath, about 3 x the length of my necklace.
    I double it, so I have a loop on one end.
    The very thin threath on my temporarely string I attach to my new threath, on the loopside.
    So I can SLIDE the pearls from one threath to the other. Saves you a lot of stringingtime like this.

    So with all my pearls on my new threath, I attach a clasp on one side.,the side I start knotting.
    I make handover knots, don't use a tweezer but a strong nail, that I put in the knots to slide It against the pearl, and leave it there until my next pearl is snug against the former one and keeps the knot in place. Then I remove the nail, make my next knot etc. etc.

    Quite difficult to describe, doing it goes faster. It takes me about 15 min. to knot an average necklace.
    Hope it's of any help to you, if it's not clear, just ask.
    Marjan

  10. #10
    Satine De La Courcel
    Guest

    Default

    As far a one stringing all method. I Would sugggest trying different methods and figuring out what one workd best for you. you have been given some good resources by several perople her.. all are good and I honestly feel its personal preferanc as to what works for you....

    Good Luck!

    Ashby

  11. #11
    pearltime
    Guest

    Default

    Thanks everyone for all of the info.

    Karen

  12. #12
    purepearls
    Guest

    Default

    Ashby is right! Trying several methods will allow you to find what you are best at. Everyone is different! Once you get it down, you'll be able to perfect your technique and string quickly. Good luck!

  13. #13
    himal
    Guest

    Default

    Hi Marjan
    I tried to use your stringing method but could not understand attaching the new thread with temporary thread.

    Could you please explain about it ?

    Thanks
    Himal

  14. #14
    dutchpearl
    Guest

    Default

    when you buy a strand of pearls they are usually strung on a double temporary threat, knots on both ends to prevent the pearls from sliding of.

    On one side, remove one of the threats and split the remaining one into as many parts as you can, cut all exept one.

    Then you take the new threat, fold it so that you have a loop on one end.

    If you now attach the tiny threat of the temporarely strand to the permanent one, the knot that you attach it with, is so small that yuor pearls can slide over it to your new threat.

    Especially with very small pearls or beads, it saves you a lot of stringing work.
    Hope it's clear now.
    Marjan

  15. #15
    gia student
    Guest

    Default knotting pearls

    me personaly never used any tools to knot my pearls i use just my fingers and i have consistant knots that are snug agaist the pearls but not so snug the necklace is stiff mine are very fluid in movement.
    Last edited by gia student; 05-04-2006 at 03:07 PM.