| Thanks Caitlin. I have been surfing all afternoon with your advise. Hye on Beads is temporarily closed and Artbeads was not listing Danyline. My problem is the holes are so tiny on the keishis I can't get any needle type through them. I must use a built in needle. There is a Griffon High Performance number 2 with a built in needle. I am going try that and some special cutters, as it is very stong. Wow is it hard to find. Finally found it on Craftland. Hopefully this will work. Perhaps there is some needle out there small enough for the keishis, but I have not found it. |